The method to Replace Magnets Under an iBook Keypad
The Apple iBook has a magnet beneath the Fujitsu Laptop Keyboard aligning the arrangement of pair chapters of its inner shell together. Replacing the magnet, must the strength of the magnetic drag be lessened from age, requires a partial disassembly of the iBook. The method requires the exert of a minority domestic tools, but no special electronic skills.Place a bath towel on a table. Remove any cables connected to the iBook. Place the iBook face down on the bath towel. Remove the three screws from the bottom with the Allen wrench.
Insert the tip of the flat-edged jeweler's screwdriver into the center hole of one of the rubber feet that are on the bottom. Lift onto the tip to loosen the rubber foot. Pull the rubber foot off with your hand. Repeat this with the other rubber feet. Remove the screws hidden via the rubber feet with the Phillips jeweler's screwdriver. Remove the iron ring from indoor of each of the rubber feet.
Insert a coin into the slot via the battery compartment. Turn the coin clockwise to discharge the battery. Remove the battery. Remove the pair screws each on the outdoors and indoor of the battery compartment with the Phillips jeweler's screwdriver.Turn the iBook over. Raise the lid. Rotate the iBook so that you are gazing at the LCD screen as you would normally.
Pull rear on the tabs that are on the retired and right side at the lid of the keyboard--each tab is between a "F" key. Carefully elevator the keyboard off the iBook. Place the Acer laptop Keyboard to the side, taking care not to disconnect the wire connected to the keyboard.Unplug the antenna wire entering the Airport mobile card that is at the middle of the compartment now vacated via the keyboard. Pull the AIrport mobile card to the right and out of the compartment
Remove the screws enclosing the Airport mobile card's grooved slot with the Phillips jeweler's screwdriver--the screws are situated at your upper retired corner, to the retired of the grooved slot and at the cheaper right corner. Remove the pair screws from indoor of the grooved slot with the Phillips jeweler's screwdriver.
Remove the iron frame enclosing the grooved slot with your fingers. Insert the tip of the Phillips jeweler's screwdriver into an fringe of the magnet that is to the retired of the grooved slot-the magnet is following to the now disclosed iBook's passport code sticker. Lift onto the tip of the Phillips jeweler's screwdriver to loosen the magnet. Pull the magnet off and dispose of it properly.
Insert the replenishment magnet into the hole now vacated. Place the iron frame rear onto the iBook. Reattach the screws.
Insert the Airport mobile card rear into the grooved slot. Reattach the antenna cable.
Pull rear on the pair tabs whereas reattaching the Hp Laptop Keyboard to the iBook. Release the tabs.
Close the lid. Turn the iBook over. Reattach the screws indoor and outdoors of the battery compartment. Place the battery rear into the battery compartment.
Place the iron rings rear not the rubber feet. Reattach the screws in the rubber feet. Reattach the screws on the bottom of the iBook. Turn the iBook over.
